Injection molding machine is the thermosetting plastic into different shapes of the mold, the final realization of plastic products molding equipment. And extra large injection molding machines use electromagnetic heaters to achieve the effect of energy saving, and in terms of power consumption and energy saving, the frequency converter is selected to change the power frequency of equipment operation, so the reliability is better, so it is necessary to make a better choice according to the actual situation, and the final reliability will be greatly improved.

Of course, high quality large injection molding machine energy saving consumables are realized from the heating and power two aspects, so it is necessary to make a better choice according to the actual situation, the quality assurance will have a more outstanding performance, so the final reliability will be greatly improved.

Energy saving of heating part:

Extra large injection molding machine choose electromagnetic heater can save heating time, directly acting on the heating pipe, special insulation layer can improve heating efficiency, at the same time high heating efficiency. These are all reasons to ensure greater energy efficiency. In the past, the resistance heating coil has low efficiency and large heat loss, so it consumes a lot of electricity, so the cost of processing plastic products has been greatly increased.

We choose the highest quality large injection molding machine can achieve the best energy saving effect.

Energy saving in power:

If the power of the extra large injection molding machine is only 30HZ during operation, the actual power of the motor may be larger, so it will cause energy waste. Then choose the frequency converter to adjust, can ensure that the equipment needs much power, how much power output. Therefore, the energy saving effect that can be achieved in the end must be the best, so the reliability will be better.